Today we’re making the switch from carpeted stairways, to one of hardwood treads and risers.
Why remove the carpeting off your stairs? Well, presuming you’ve already replaced your once-carpeted floors with hardwood, this natural progression completes the project, enabling your stairs to have the same clean, good looking status of your hardwood flooring.
Step one, carefully tear back the carpeting off of “one” step. Don’t remove all the carpeting just yet. The removing of only one step of carpeting will allow you to do some measuring, followed by a bit of research, with the development of a strategy to come next.
This as opposed to creating a scenario where the carpeting has been completely removed, exposing your family members to a minefield of carpet staples until the point in time when you get yourself organized.
The most efficient way of replacing stairway carpeting with hardwood treads is by choosing the “simple tread” kit. These tread kits provide you with one hardwood tread and one riser, in either an oak or maple species of wood.
The wood grain patterns of oak and maple differ considerably, so be sure to inspect the grain patterns of your flooring to ensure compliancy with the treads.
If your hardwood treads are to be painted, choose maple, its smoother and harder finish will provide better results.
Basically, we’re installing new treads and risers over the existing treads and risers.
The advantage to re-treading, as opposed to buying regular stair treads and risers, is the kits’ tread is a thinner, laminated version of what’s standard, allowing you to more easily secure it to the existing spruce or particle board tread. The re-tread also comes with a wide, decorative nosing, which creates a ledge that will be strategic in hiding the edge of the existing tread.
The strategy to using the simple tread kit will involve removing the nose (portion of overhang) of the existing tread, creating a square or flush surface to which to mount your hardwood tread and riser. So, measure the overhang or nose portion of the existing tread (which should be about 1.25 to 1-3/8 inches) then subtract this figure from the total depth of the tread. Hopefully you’ll be left with a depth of 9-1/8 inches or less, with 9-1/8 inches being the total maximum depth that your re-tread will cover.
If for some reason, we’ll call it carpenter’s choice, the person who installed the treads 25 years ago chose to make the treads a little deeper than standard, then you’re going to have a situation where the re-tread’s depth is insufficient.
This is when you either pursue further re-treading strategies, or re-tack the carpeting back in position and get back to your basement beer-making venture. However, and in the interest of progress, since the odds of you causing an explosion, or creating a barely consumable sludge, likely outweigh that of you driving an air nail through your thumb, let’s stick with the stair project.
If the existing tread, once cut, exceeds 9-1/8 inches, then options to solving this spacing issue will include adding a cove or quarter-round molding where the re-tread meets the riser, alternatively using a standard tread, or if possible, trimming the nosing on the re-tread. Regardless, it’ll simply require a little bit of extra finishing carpentry.
If the existing tread, once cut, will be 9-1/8 inches or less, then we’re in business to go forward with the simple tread kit as is.
Keys to success?
One, pre-stain and clear-seal (three coats) your simple treads and risers, as well as any other necessary trim pieces or moldings, beforehand, letting them cure for at least a week before installing. Staining one day, clear coating the next, should you choose to install first, then finish, will undoubtedly leave footprints, which will be disastrous.
Two, put a new blade on your chop saw and table saw.
And three, limit chipping by first scoring the finished surface with a utility knife, then cut on this finished side.