Case no. 822, titled “don’t float me,” examines the flooring issues experienced by a Mr. Gerard Boyance, aka “Flottant” (the Floater), due to the pronunciation of Gerard’s last name sounding much like the term buoyancy, and Flottant’s propensity to wear soft-soled loafers.
Besides liking comfort, Gerard is also a big fan of those products that are easy to maintain, which led him to choose a vinyl “click” flooring for his kitchen and living room renovation.
The past 12 years had Gerard enjoying a 12-millimeter laminate, or composite type of floating floor, which over time had lost some of its sheen due to regular wear and tear.
Choosing a PVC vinyl click floor for this renovation was an easy choice for the Floater due to the toughness of the PVC finish, it’s very realistic wood colouring, and the fact PVC products are extremely resistant to moisture. Those features make it the perfect floor for Gerard, who enjoys cooking, and his four cats, who sometimes create their own mess during episodes of territorial marking.
Being handy in the ways of general finishing, and having installed his laminate/composite drop-click flooring years before, Gerard felt comfortable installing this new PVC click flooring himself.
Following the basic rules of click or tongue-in-groove type floorings, Flottant began installing the PVC flooring in the usual manner, with the tongue edge facing the wall, while using shims around the perimeter of the room to provide the necessary half-inch expansion and contraction spacing required between wall and flooring product.
Gerard’s expertise and proficiency in handling the click flooring allowed him to finish laying the product within a few hours, with a shoe molding installed afterwards to cover the required perimeter spacing.
With the job completed, Gerard proudly floated over his newly laid floor, touring back and forth from living room to kitchen with his Bona spray mop, making sure things looked just perfect for his hosting of an upcoming meeting of the bridge bunnies, a local group of card-playing seniors, that afternoon. After a successfully hosting of the bunnies, where Gerard only had to deal with some mild dramatics due to Thelma’s questionable card counting and Ernie’s habit of littering the table with cookie crumbs, the floater was once again manning the Bona mop.
This time around, the Bona wasn’t sliding so freely over the floor, and upon closer examination, Gerard was blown out of his loafers to discover the planks of flooring had begun to separate. A call to the flooring manufacturer had a company representative on site a few days later. Two steps onto the floor, the sales rep paused, momentarily shifted his weight from side to side, then, proceeded forward once again.
“I think I know what the problem is,” the rep stated matter-of-factly.
In an attempt to transfer the cushioning action of his existing floating laminate floor to that of his new PVC vinyl floor, Gerard chose not to remove the existing foam underlay. That was a mistake. Perhaps it was the term float that confused Gerard.
Unfortunately, regular laminate foams are too thick, and soft, for the thinner PVC floorings, and will cause the PVC joints to work excessively. PVC vinyl clicks and LVT butt-edge floorings don’t need to be glued down, so they do indeed float.
However, they must be laid directly on a solid substrate such as concrete or plywood.
Is there an underlay foam suitable for PVC vinyl click and LVT vinyl floors, offering some comfort and sound deadening value? Yes— look for a thin, high-density, rubberized matting made especially for vinyl flooring.
Solution to Gerard’s dilemma?
The PVC flooring will need to be carefully un-clicked and set aside, the old foam tossed out, with the vinyl click re-installed over the plywood substrate, or the aforementioned rubber matting.
Certainly a pain in the butt for our Gerard “Flottant” Boyance, but unlike most flooring cases, far from a total loss.
Case no. 822 closed.